Roth ShuntUnit, 1-8 branches - With/without flow meter


With pre-assembled distribution pipes and automatic air vent program.
Roth ShuntUnit, 1-8 branches are used for smaller floor swavel systems - both in new construction and renovation tasks. Roth ShuntUnit, 1-8 branches have a capacity of up to 160 m² depending on the actual heat loss. Roth ShuntUnit is used on systems where the heat source provides a higher flow temperature than is used on the underfloor heating system.

Roth ShuntUnit, 1-8 branches are supplied with an A-marked pump, which ensures minimal electricity consumption. The pump, which includes an automatic air vent program, is pre-mounted on the left side of the distributor pipes, but can easily be moved to the right side. The Roth ShuntUnit comes with pre-assembled distributor tubes with 1-8 branches prepared for mounting Roth room control. Roth ShuntUnit can be expanded with several branches using expansion sets.

 

Downloads

Roth ShuntUnit Mixer

Roth ShuntUnit
With/without flow meter

Wilo Para pumps

Technical data:

Max. operating temperature:95°C
Max. differential pressure:50 kPa
Max. Operating pressure:6 bar
Pump:Wilo Para 15-130/6-43/SC-12
Pump output:3 - 43W
Temp. control range:20 - 60°C
Thread primary side:½ “BSP
Thread on the branches:EURO ¾ “ext.
Gevind på afgreningerEURO ¾” udv.
Material:Brass CW614
Gaskets:EPDM
Mounting bracket:Galvanized steel
Electrical connection:230V
Flow meter, Kvs1,12 (m3/h)

 

Roth insulation for Roth shunt

Roth insulation is easy and practical to put on the Roth shunt and ensures a nice finish of the underfloor heating installation. Roth insulation has cutting lines that make it easy to customize it if you need to shorten it.

Roth insulation is prepared for installations with the pump mounted on the left, but can easily be changed if the pump is desired on the right side. For larger plants with shunter, you can extend with our universal insulation jacket for distributor pipes.

Roth insulation for Roth shunt with distributor up to 3 branches, plumbing no. 401973.892. Roth insulation for Roth ShuntUnit with up to 6 branches, plumbing no. 401973.891.

  1. Perfectly suited for shunt with both thermostatic valve and road compensation plant
  2. Can be easily cut with a knife when using the cutting lines
  3. Meets the requirements of DS 452
  4. The pump can be mounted both on the left and right
  5. Strong material that does not crack
  6. Contains flame retardant material
  7. Nice finish on the underfloor heating installation
  8. Delivered fully assembled - ready for installation

 

For more informations?