Roth Knob panel PS20, EPS30 and EPS50

Roth Knob panel PS20, EPS 30/10, EPS 50/30 can be used for new construction and renovation tasks where the underfloor heating pipes must be cast in concrete or floating putty.

It is a plate system developed for structures where you want to cast on top of the underfloor heating hoses. For the system plates, 16 mm underfloor heating pipes are used.

Important
If you use the underfloor heating to dry out the concrete, do this at a low flow temperature, typically 5 degrees higher than the concrete temperature. Always ask the concrete supplier before starting drying out. In larger buildings such as warehouses and industrial buildings, the floors are divided into smaller areas, this is done with dilation joints. In places where the underfloor heating pipes cross the joints, they must be protected from the movements of the concrete surfaces, this can be done by putting on a piece of Roth empty pipe. Be aware of the stricter requirements for insulation when there is underfloor heating in terrain decks and follow current BR and other rules carefully.

Technical data

Roth Knob panel 14-16mm without EPS1135006031
Roth Knob Panel 14-16mm EPS 10mm1115007914
Roth Knob Panel 14-16mm EPS 30mm1115007913

Technical Data

Roth Knob panel 14-16mm without EPS1135006031
Roth Knob Panel 14-16mm EPS 10mm1115007914
Roth Knob Panel 14-16mm EPS 30mm1115007913

For more information on our products

Downloads

Get more information in our datasheets and brochures